FOREVER Flex Soft (No-Cut) Blue Metalic

Transfer foil in A3 format for laser printers and copiers.

No more cutting and weeding. You just print desired graphic in black color and get blue metalic color!

• no more time-consuming cutting and weeding
• low temperature 100-160°C
• suitable for almost all fabrics and hard surfaces (cotton, blended fabrics, polyester, nylon, polypropylene, paper, wood, etc.)
• suitable for black & white or CMYK laser/LED printers and copiers
• washable up to 40°C
• easily print even complicated graphics with lots of details
• saves your time
• size A3

METHOD:

1. Print desired design mirrored on coated side of A-foil.
   02. Cut 1cm from A-foil on each side.
   03. Pre-heat heatpress until the bottom board with silicone pad will become hot.
   04. Lay 1 or 2 sheets of office paper on the silicone pad to protect the pad.
   05. Put cutted A-foil to the center of the heatpress with printed side facing up.
   06. Lay B-paper Low Temp on top of the A-foil with coated side facing down.
   07. Lay 1 or 2 sheets of office paper on it.
   NOTE: B-paper Low Temp is bigger than A-foil to prevent mistakes.
   08. Iron together A-foil and B-paper:  Temperature - 130 – 145°C
                                                           Time- A4 - 90 seconds / A3 - 120 seconds
                                                           Pressure - 2-3 bars (30-40PSI) medium
2. After opening the heatpress, take a piece of cloth and rub the B-paper for 5-10 seconds.
   10. Detach B-paper and A-foil without lifting them from the pad. Proceed slowly but without stopping!
   11. Lay down the t-shirt on silicone pad of the heatpress.
   12. Lay down prepared motive and fix with thermo-tape.
   13. Place a sheet of Matt Finish Economy paper.
   14. Iron according to parameters written in the table below.
   15. Fot better resistance during cleaning and washing, it's necessary to put the Matt Finish Economy or Glossy Finish paper on top of the ironed motive and iron it again for 30 seconds.

>> TEMPERATURE, TIME & PRESSURE TABLE